Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LACP between different speed ports

In Cisco Catalyst switches, Is LACP doable between 1Gb and 10Gb ports.  In other words if I want to configure LACP between two Cisco switches.  Can I take (2) 1Gb and (2) 10Gb ports from each switch and configure LACP?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

LACP between different speed ports

EtherChannel technology is not dependent on any type of media. it can be used with Ethernet running on copper wiring, or single-mode and multimode fiber, no problem.

plz Rate if it helped.

Soroush

Hope it Helps!

Soroush.
3 REPLIES
Gold

LACP between different speed ports

Hi,

No, you can not pair mismatch speeds in one bundle. etherchannel is doable between different speeds from 10Mbps to 10Gbps, but all the links in a bundle must be of a same speed and duplex configuration.

you can read more here:

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_white_paper09186a0080092944.shtml

plz Rate if it helped.

Soroush.

Hope it Helps!

Soroush.
New Member

Re: LACP between different speed ports

Hello

Gold

LACP between different speed ports

EtherChannel technology is not dependent on any type of media. it can be used with Ethernet running on copper wiring, or single-mode and multimode fiber, no problem.

plz Rate if it helped.

Soroush

Hope it Helps!

Soroush.
2978
Views
0
Helpful
3
Replies
CreatePlease login to create content