Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LACP between Nexus 5K (VPC) and HP Servers

Hello!

I have two N5K (5020) switches with NX-OS - 5.0(3)N2(1).

These two switches form VPC domain: peer-link = 2*10Gb ports (1/17-18) and peer-keepalive link over managements ports.

Also I have two HP servers with two 10 Gb ports on each server.

Each server conected by one link to each N5K switch (1/9-10). N5K downlinks configured as access ports with LACP Active mode.

There is only one VLAN (1).

When "no shut" command entered on N5K access ports - ports going in "not connected" status, begin flap and then going in "linkFlapErrDisabled" state.

In attach - "sh run" from N5K.

Please help to troubleshoot this problem.

Everyone's tags (3)
1 REPLY
New Member

LACP between Nexus 5K (VPC) and HP Servers

We are experiencing the same issue. Has there been a resolution on this problem?

2034
Views
0
Helpful
1
Replies