Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LACP config on 3560G switch

need help on configuring LACP on switch. Currently the config is as follows

switchport access vlanx

switch mode access

channel-group 5 mode active

I want to make sure if this config is correct and if there is anything missing. Please advice.

3 REPLIES
Hall of Fame Super Silver

Re: LACP config on 3560G switch

Hello Anand,

this configuration is correct if you want to build a L2 bundle that carries only vlan X traffic.

Be aware that if other side doesn't send LACP frames the switch will disable member ports after some seconds.

So configure it after the server is ready (if there is a server on other side)

Hope to help

Giuseppe

Silver

Re: LACP config on 3560G switch

What are you connecting to this port? a multiple NIC server?

You need to make sure the other device speaks 802.3ad as well in order for the etherchannel to be negotiated.

What kind of Cisco switch is where you are configuring this? Sometimes is important to verify that the modules (if any) have the same queuing characteristics and such.

New Member

Re: LACP config on 3560G switch

As I said I have configured this on 3560 cisco switch, also this is one of the requirement for our VM Ware project.

1140
Views
0
Helpful
3
Replies