Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LACP ISSUE ON NEXUS 5548

 

HI,

i have some servers connected to these ports i see port-channel is up....can any one tell me what exactly "[LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED] "  means ????

 

FSM:<Ethernet106/1/13> Transition at 555079 usecs after Fri Jun 20 20:15:20 2014
    Previous state: [LACP_ST_WAIT_FOR_HW_TO_PROGRAM_TRANSMIT_PATH]
    Triggered event: [LACP_EV_PORT_HW_PATH_ENABLED]
    Next state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]
    Curr state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]


FSM:<Ethernet106/1/14> Transition at 558271 usecs after Fri Jun 20 20:15:20 2014
    Previous state: [LACP_ST_WAIT_FOR_HW_TO_PROGRAM_TRANSMIT_PATH]
    Triggered event: [LACP_EV_PORT_HW_PATH_ENABLED]
    Next state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]
    Curr state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]


FSM:<Ethernet106/1/15> Transition at 655069 usecs after Fri Jun 20 20:15:20 2014
    Previous state: [LACP_ST_WAIT_FOR_HW_TO_PROGRAM_TRANSMIT_PATH]
    Triggered event: [LACP_EV_PORT_HW_PATH_ENABLED]
    Next state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]
   Curr state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]


FSM:<Ethernet106/1/16> Transition at 658790 usecs after Fri Jun 20 20:15:20 2014
    Previous state: [LACP_ST_WAIT_FOR_HW_TO_PROGRAM_TRANSMIT_PATH]
    Triggered event: [LACP_EV_PORT_HW_PATH_ENABLED]
    Next state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]
    Curr state: [LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED]

2 REPLIES
VIP Super Bronze

Hi,Can you post configs from

Hi,

Can you post configs from the both 5ks?

Also, post the output of "sh ether-ch summ"

HTH

Cisco Employee

Hi,As I saw it before, these

Hi,


As I saw it before, these are just LACP status transition to Curr state: "LACP_ST_PORT_MEMBER_COLLECTING_AND_DISTRIBUTING_ENABLED" which means that LACP is ok. :)

 

When you see any other output from "sh lacp internal event-history interface e1/x " command, better check if this interface  or LACP is flapping .

 

HTH

Jay Ocampo

83
Views
0
Helpful
2
Replies
CreatePlease to create content