08-21-2013 01:43 AM - edited 03-07-2019 03:02 PM
Hello Guys,
I have a Nexus 5548 that i connecting to an ESX Virtual Server with a virtual switch between.
i have a port channel connection from the Nexus to the virtual switch. The question is would there be any risk of not having the lacp suspend-individual command on this port channel?
Currently without this command, the port channel is in an individual state.
Thanks in advance for the feedback.
08-21-2013 11:05 AM
Hi,
I think, you apply it if you need it.
To enable individual Link Aggregation Control Protocol (LACP) port suspension behavior on a port channel, use the
lacp suspend-individual
command. To disable individual port suspension behavior on the port channel, use the
no form of this command.
.
HTH
08-21-2013 12:33 PM
Since the port-channel is in individual state, if you apply the command it will go to the suspened state. Please check the below thread
https://supportforums.cisco.com/thread/2136554
Siddhartha
08-21-2013 11:44 PM
thanks for your response guys
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: