I Have a FWSM running in multiple context mode with two context configured, each context is using a differente SVI for communication between the MSFC and the FWSM. From the beginnign the solution has been workin fine and traffic between contexts and DMZ flows without problem, however when in type a "show interface" for the SVI's in the MSFC to see the traffic passing to each context, the counters of the SVI's don't register any traffic in the 5 minute input/output. Currently the switch is running in Hybrid mode (CatOS/IOS). Previously I have installed another FWSM's in a very similar scenario but using switches in NAtive mode and in the case the shi interface for the SVI's do detect the traffic passing to the context's, is it normal this behavior for the Hybrid switch ???
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...