cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
544
Views
0
Helpful
1
Replies

Layer 2 ACL (MAC based) on Layer 3 interface

shah.chintan
Level 1
Level 1

Hi,

Is it possibel to configure Layer 2 ACL (I need to configure this to block Multicast frame) on Layer 3 interface ?

Regards,

Chintan.

1 Reply 1

shah.chintan
Level 1
Level 1

Hi,

I've configured below MAC-address ACL

mac access-list extended MULTICAST

permit any host 0100.5e00.000d

I've Layer 3 interface connected to layer 2 network and I've also applied Storm-control on My layer 3 interface for Multicast storm.

Now, I wanted to block multicast packets comming from layer 2 network to my layer 3 interface execpt abvoe one. I was planning to use Layer 3 based ACL but as storm-control apply first and i will lost my genuine packets with strom, so i wanted to apply MAC based ACL on L3 so that genuine packet doesnt' get drop by ACL/storm control.

Unfortunately, I'm not able to apply thie MAC based ACL on routed port on 6500 12.2 IOS.

Can any one suggest better solution for this issue ?

IF it is needed i can provide more info...

Thanks in advance.

Chintan.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card