Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

layer 2 or layer 3 issue ?

Hi everybody,

in order to connect a LAN to 02 redundant routers like the attached diagram, the question is when the port Gi0/1 in 2960 switch is active and Gi0/2 is blocked, all the 03 devices are reachable (respond to ping) and traffic goes through, but when port Gi0/1 is DOWN and the port Gi0/2 is active, the routers are not rechable from 2960 switch and no traffic is possible between switch and routers.

any suggestions ?

thanks.

3 REPLIES
Silver

Re: layer 2 or layer 3 issue ?

where is the attached diagram?

Silver

Re: layer 2 or layer 3 issue ?

Hi There

If you look a little further down the list of posts you will see a post titled "Layer 2 or Layer 3 issue, (diagram added)" which has the diagram.

Best Regards & Best Wishes for 2008 and beyond,

Michael

Silver

Re: layer 2 or layer 3 issue ?

i really can't find the diagram!

117
Views
0
Helpful
3
Replies
CreatePlease to create content