I am looking for Layer 3 redundancy for my design and I am not sure about how to set it up. I think based on my current design I will have to use OSPF costing to ensure that the primary link is always primary. I dont see a way of using HSRP since the connections that are coming in to each router reside on separate routers. Any help would be greatly appreciated.
OSPF should work fine. By default, since your primary circuit has higher bandwidth (3mb) and lower cost, it will the primary interface. The T1 will be the backup interface sine it will have higher cost (64).
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...