Layer 3 (SVI) and Layer 2 (switchport mode access)
Please refer to the attached block diagram:
I have three 3560 switches, two configured as Layer 2 and 1 as Layer 3. I am able to route multicast
data from the Layer 2 switch to the Layer 3 switch and end device using SVI's on Port 6 (VLAN 39) and Port 16 (VLAN 45) using the configurations as shown. The end device receives the proper multicast data.
On the Layer 2 switch as shown, all ports have VLAN 39 also configured. Multicast data continues to flow down from the top Layer 2 switch through the EtherChannel configuration down to the (3) end devices. However, after a couple of minutes data stops flowing to the end devices. When I disconnect the cable between the Layer 3 and 2 switches, multicast data starts to flow once again to the end devices.
Unable to figure out why data stops flowing. Could use some help on this one.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.