It appears R2 doesn't know how to route traffic to 10.6.2.x network. Add static routes on R2 to route traffic to vlan 2 & 3 to forward the traffic to the 3550 switch. Alternatively, you can enable a dynamic routing protocol between the 3550 and R2.
Yes you either have to add static routes on both sides so that both sides know how to get to the subnets on the other box or implement a routing protocol like ospf or eigrp. Static routes are a pain to keep up use a routing protocol if possible and the 3550 supports it.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.