This morning, I configured 2 6500 appliances with VS supervisor in order to setup a Virtual Switching between them. Everyting is ok, console on standby is disabled, for instance, but the LED labeled como Active on Standby appliance is green instead of orange.
I attach the show redundancy command, as you can see one of them is ACTIVE and the other one STANDBY HOT. I think all is working properly (the hardware is not in production yet) but I am concerned about the LED color.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...