We are looking to implement the C2921 solution in our new office and I am getting confused with the sort of licences and extra modules required to make this happen. If anyone of you understands the Cisco licencing requirements I would be grateful for some guidance.
Here is what I have been told so far:
a) that we need to purchase the following hardware:
VIC3-4FXS/DID Four-Port Voice Interface Card - FXS and DID
1. is the licence suggested on the actual phones not duplicate the licences already purchased with the c2921 router? I noticed there is another code for these phones which does not carry the licence (CP-7945G) and these are obviously cheaper.
2. are there any other ways which are more cost effective to purchase the licences? are there licences we require which the Partner did not specify as per the above list?
ISM-SRE-300-K9 Internal Services Module (ISM)
FL-CUE-PORT-2 Unity Express License - 2 Port
d) that we need to purchase phones that come with an extra licence:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...