Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

License for load balance

hello,

I would like know, what license is necessary to employ a load-balance in a 2911 router. I have these licenses bellow, can i configure an load balance?In this cenario we have two links with an ISP.

Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(2)T1, RELEASE SOFTWARE (fc1)

Cisco CISCO2911/K9 (revision 1.0) with 479232K/45056K bytes of memory.

Processor board ID FTX1613AH8D

1 FastEthernet interface

3 Gigabit Ethernet interfaces

1 terminal line

2 Channelized (E1 or T1)/PRI ports

1 Virtual Private Network (VPN) Module

DRAM configuration is 64 bits wide with parity enabled.

255K bytes of non-volatile configuration memory.

250880K bytes of ATA System CompactFlash 0 (Read/Write)

Technology Package License Information for Module:'c2900'

-----------------------------------------------------------------

Technology    Technology-package           Technology-package

              Current       Type           Next reboot

------------------------------------------------------------------

ipbase        ipbasek9      Permanent      ipbasek9

security      securityk9    Permanent      securityk9

uc            uck9          Permanent      uck9

data          None          None           None

Thanks!

Everyone's tags (4)
1 REPLY
New Member

License for load balance

Hi Rodolfo,

The device 2911 router is Enterprise level and you posted your question in Small Business Forum.  You might consider to ask this question at Enterprise forum to get a better response.

https://supportforums.cisco.com/index.jspa

Sincerely,

Alena Patterson

Cisco SB Engineer

CCNA, CCNA Wireless

261
Views
0
Helpful
1
Replies
CreatePlease login to create content