Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

limit a port to 200 megs

I have a 3550-12g switch software Version 12.2(44)SE5 I have a customer that wants a 200meg connection…They're plugged into port 4 with a LX gbic…What would be the best way to only allow 200meg in or out of that port?

2 REPLIES

Re: limit a port to 200 megs

Hello.

This should do it:

mls qos

!

policy-map SHAPE_ME

class class-default

police 200000000

!

interface GigabithEthernet0/1

service-policy output SHAPE_ME

service-policy input SHAPE_ME

Simon

Hall of Fame Super Silver

Re: limit a port to 200 megs

Hello SG,

you can use modular QoS

service-policy {input policy-map-name | output policy-map-name}

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.2_44_se/configuration/guide/swqos.html#wp1044737

output direction requires more care.

Policers can be configured only on a physical port or on a per-port per-VLAN basis (specifies the bandwidth limits for the traffic on a per-VLAN basis, for a given port). Per-port per-VLAN policing is not supported on routed ports or on virtual (logical) interfaces. It is supported only on an ingress port configured as a trunk or as a static-access port.

•Only one policer can be applied to a packet per direction.

Hope to help

Giuseppe

116
Views
0
Helpful
2
Replies