Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Limit rate with burst speed

I am trying to setup a 3550 switch to limit download speed to 25mb and upload 10mb on each port.  I am confused on what to set my rate at and burst rate. Also do I have input vs output correct on my interface?  Thank you for your help in advance.

mls qos

!

policy-map 25MB

  class class-default

    police ? ? exceed-action drop

policy-map 10MB

  class class-default

    police ? ? exceed-action drop

Interface fa 0/1

switchport access vlan 10

switchport mode access

service-policy input 10MB

service-policy output 25MB

Everyone's tags (1)
2 REPLIES
New Member

Re: Limit rate with burst speed

This is what I have come up with, will this work on a 3550 switch to limit bandwidth per port?

mls qos

!

policy-map 10meg

class class-default

police 10000000 125000 exceed-action drop

!

policy-map 25meg

class class-default

police 25000000 312500 exceed-action drop

!

policy-map 50meg

class class-default

police 50000000 625000 exceed-action drop

!

!

!

interface FastEthernet0/1

service-policy input 25meg

service-policy output 10meg

New Member

Re: Limit rate with burst speed

That solution will not work.  This is the solution I used and cofirmed working on cisco 3550 switches.

mls qos

!

class-map match-any ACL_IN 

  match access-group 100

class-map match-any ALL_OUT 

  match ip dscp 0 

policy-map 25MBOUT_DOWN 

  class ALL_OUT 

   police 25000000 512000 exceed-action drop 

policy-map 50MBOUT_DOWN

  class ALL_OUT 

   police 50000000 768000 exceed-action drop 

policy-map 10MBIN_UP 

  class ACL_IN 

   police 10000000 512000 exceed-action drop

policy-map 20MBIN_UP 

  class ACL_IN 

   police 20000000 512000 exceed-action drop

!

end

!

access-list 100 permit tcp any any

408
Views
0
Helpful
2
Replies