Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

limt the access via routing protocols

Hi

we want to limt the access between branches without ACL, we have EIGRP,OSPF ,STATIC route in our routing table. could I do it with route filtering? is it a good solution?

could you pls tell me the other solution for this subject?

we have some problems with ACL in branches .

with these routing protocols , could we use route filtering?

thanx

1 REPLY
Cisco Employee

Re: limt the access via routing protocols

Hello,

You can configure the route filtering on the routing protocols mentioned above.This is a typical configuration used in a hub-spoke topology. Please see the links below for more info on this:

http://www.cisco.com/en/US/tech/tk365/tk207/tsd_technology_support_sub-protocol_home.html

http://www.cisco.com/en/US/tech/tk365/tk480/tsd_technology_support_sub-protocol_home.html

HTH,

-amit singh

122
Views
0
Helpful
1
Replies
CreatePlease to create content