Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Line Card failure when Converting From IOS to CATOS on Sup 720-3b

Hi,

Has anybody had any issues when converting from IOS to CATOS on a 6500 switch with a Sup720-3B. My problem is when the switch is runnig IOS, it recognises the Line cards. As soon as I convert to CATOS (cat6000-sup720cvk9.8-5-5.bin),all line cards except the superviisor come up as faulty, when I do a show Mod. The supervisor itself boots correctly and I have full CATOS commands. Has anybody seen anything similar?

1 REPLY
Silver

Re: Line Card failure when Converting From IOS to CATOS on Sup 7

check out the following link for step by step instructions for Software Conversion from Cisco IOS to CatOS for Catalyst 6500/6000 Switches, hope this helps :

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801350b8.shtml

194
Views
0
Helpful
1
Replies
CreatePlease to create content