Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Line Card Failures?

Hope someone can help me brainstorm this issue:

Catalyst 6509

WS-X6K-SUP1A-2GE

WS-F6K-MSFC

WS-X6248-RJ-45

WS-X6248A-TEL

WS-X6248A-TEL

WS-X6148-RJ-21

WS-X6248A-TEL

WS-X6408A-GBIC

We've had the line card module in slot 4 fail multiple times over the last few months. By fail, I mean it goes into "other" state and all ports are listed as "errdisable." We've also had the module in slot 5 fail twice with the same symptoms.

We recently had the sup fail along with the line card, so since we had a spare chassis, I swapped that while I was at it in an attempt to eliminate the chassis as a potential culprit.

I've had this issue with both WS-X6148-RJ-21 and WS-X6248A-TEL modules. Cisco has done a site analysis regarding proper grounding etc. and we have since had a contractor perform the grounding per Cisco, so I can't see that as an issue.

Furthermore, we have 9 other chassis throughout our campus with the exact same setup running the same FW/SW revs so I'm not seeing it as a bug as this issue has been isolated to this one location and specific slot(s).

At this point I'm left to think it's something on the physical layer - 25pr telco cables, patch panel - something? Any thoughts would appreciated.

  • LAN Switching and Routing
3 REPLIES
Hall of Fame Super Bronze

Re: Line Card Failures?

I swapped that while I was at it in an attempt to eliminate the chassis as a potential culprit.

I've had this issue with both WS-X6148-RJ-21 and WS-X6248A-TEL modules.

I'm sorry - you lost me there. You meant to tell us that the problem is reoccurring with the replaced chassis as well?

It can also be another module (brought from the defective chassis) that is causing the problem.

__

Edison.

Bronze

Re: Line Card Failures?

You would need to tell us exactly what log messages you had at the time which would indicate the failure reason - such as SCP ping failure, COIL Packet buffer error etc.

Also you should mention what version of IOS/CatOS you are running.

Lastly, what errdisable reason was logged when the ports are shutdown?

New Member

Re: Line Card Failures?

OK, try this again,

Chassis "A"

multiple failures on slot 4 with modules being RMA'd each time.

two failures on slot 5 with modules being RMA'd each time.

RMA'd chassis "A" after the following modules failed, Sup module, modules in both slots 4 and 5.

We had another chassis in our lab that was used to replace chassis "A" in order to maintain production environment.

We've now had another module in slot 4 fail.

We're running a CATOs setup (soon to be straight IOS. Version info is in attachment.

Here's the show log with the only error msgs being presented. This is from when the Sup failed:

12. 8/9/2008,10:41:47: SYNDIAGS:Local Test Mode encounters Minor hardware problem in Module #1

224
Views
0
Helpful
3
Replies
This widget could not be displayed.