Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Line Commands

Hi,

We have the normal 5 VTY lines from 0 to 4 configured on each of the cisco devices. What are line vty 5 15 used for?

Appreciate your response.

REgards

Navneet

7 REPLIES

Re: Line Commands

Hi Navneet

AFAIK you create line vty 5 15 when you have more number of users (more than 5) logging in onto your box.

You can define the same kinda policies like acess class and other timeouts on those line vtys too..

regds

New Member

Re: Line Commands

Hi,

Thanks for your reply. I have another problem. Whenever i try and login to my device through the console port it directly takes me to the Privileged mode. There is no Privilege 15 configured on my console. I have configured a local username and password, and I have given login local on Console.

Please advise.

Regards

Navneet

New Member

Re: Line Commands

Hi Navneet

Do check out whether the username/password which you are using to login via the console is configured with privilege level 15...

You can configure a username/password with level 1 or level 2 after which you can get in using enable secret/password.

if you dont want to get into super user mode then you can think off configuring some commands under the privilege mode which can be executed once you login onto the console..

regds

New Member

Re: Line Commands

Hi,

I have not configured any privilege 15 on the local username and password I have entered. It's very strange.

What might be the reason?

Regards

Navneet

Re: Line Commands

Hi Navneet

Can you post the config here ?

regds

New Member

Re: Line Commands

Please find the relevant configs attached.

Regards

Navneet

Re: Line Commands

Hi

I dont think any issues with the config posted by you with the config you have posted it works fine here taking me to the normal prompt instead of enable as mentioned by you.

regds

118
Views
0
Helpful
7
Replies
CreatePlease login to create content