Wondering if anyone knows of a command that will tell the temperature of a linecard in a Cisco 10012 router. If not, I assume I could get it via SNMP. Does anyone know of an OID that would supply that information? Thanks in advance!
"show environment" command is used to check the internal system status. The environmental monitor continually checks the interior chassis environment; it provides warnings for high temperature and creates reports on any occurrences.
Also check if "show power module " command works in this router which can give power status of specific module.
Show env only show's the input and output temperature. I am seeing a big difference between the two, so I wondering where the heat is coming from. SO I wanted to see the temp on each card individually.
I just tried show power-mod and that did not work, but thanks for the suggestion.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.