Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

link agg. for switch redundancy

I have two switches cisco 4948 and wants redundancy using link agg.

like i will connect sw1 port 21 to sw2 port 22 and either sw1 goes down sw2 should take care or both should work as active-2 mode. can i do the same? if yes then how?

if no then give me suggestion to make redundancy between switches

1 REPLY

Re: link agg. for switch redundancy

You can use an etherchannel to achieve link aggregation and redundancy. Here is a guide to help you configure an etherchannel.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.1_13_ea1/configuration/guide/swethchl.html

Mark

333
Views
0
Helpful
1
Replies
CreatePlease login to create content