Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VIP Super Bronze

Link Aggregation

Hi,

Has any one experienced deploying link aggregation between a Cisco 6509 and a Marconi BXR-5000 using 1Gig interfaces? I know they only way I can do this on Cisco devices is by using port-channel, but other venders do not support port-channel.

Thanks,

Reza

1 REPLY
Hall of Fame Super Silver

Re: Link Aggregation

Hello Reza,

in multi vendor context look for LACP support IEEE 802.3AD other vendors can give to this other names.

on cisco side you need to use

channel-group x mode active

LACP message frames are exchanged on each member link providing also a protection mechanism.

if a port misses to receive LACP frames it is put in down state.

Hope to help

Giuseppe

219
Views
0
Helpful
1
Replies