cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
95039
Views
10
Helpful
2
Replies

Link Flap error-disable

gnijs
Level 4
Level 4

All,

Could someone point me out to some documentation or explain to me what exactly is regarded as a "link-flap" for error-disable detection ?

Is this one up/down in one second ? three up/downs in 2 seconds ? four consequetive up/down ?

Geert

1 Accepted Solution

Accepted Solutions

Hey Geert,

The interface is put into the errdisabled state if it flaps more than five times in 10 seconds.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml

best regards

Sebastian

View solution in original post

2 Replies 2

Hey Geert,

The interface is put into the errdisabled state if it flaps more than five times in 10 seconds.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml

best regards

Sebastian

It is often so difficult to find the correct document on the web site. I searched for over an hour for this document. tkx.

Review Cisco Networking products for a $25 gift card