Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Link flap issues

I have a few servers that after a reboot link flap. I have the port set to recover at the default time interval. However this causes a problem with some of the servers. Ex- One of the servers is a SQL server. The services start up on this server before network connectivity is established and SQL doesn't function properly. We end up rebooting the server until it doesn't flap. It's a fiber connection to the switch (I have no idea why it's fiber) and I can't adjust the duplex speed on the card. Any suggestions? Can I disable this error detection without causing other problems? Thanks.

4 REPLIES
New Member

Re: Link flap issues

Mike,

I assume you are talking about errordisable and errordisable recovery. Which of the errordisable mechanisms is being triggered? UDLD I suspect? Let me know and I have some ideas for you.

Saro

New Member

Re: Link flap issues

From my config-

errdisable recovery cause link-flap

Thanks Saro.

New Member

Re: Link flap issues

Hi Mike,

The reason link-flapping is generally enabled in as an errordisable option is that link flaps, generally, indicate some network device is not behaving properly. In your case, that doesn't seem to be the case. It would be interesting to see why it's flapping, but that said, to make your network function better you can disable that errordisable function for linkflap on that switch without really effecting anything else. It will expose you to a link flapping causing other network problems, but that may be a more acceptable risk considering the issue at hand. At the end of the day, you'd need to figure out why that interface is flapping upon insertion.

Saro

New Member

Re: Link flap issues

in udld protocol ,what is contain information of echo packet in TLV.

273
Views
0
Helpful
4
Replies
CreatePlease login to create content