Re: Link (GBICs) Flapping on one side but not on the other side
I would try some "show controller giga" commands on both sides and look for errors.
Also, you can switch the transmit and receive on both ends (in other words, unplug side A, and plug the transmit in to receive and vise versa, then do the same to side B). If the flapping moves from the core to the other side, then it's a bad strand of fiber. If not, then you'll have to swap the GBIC's one at a time.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.