I have several Linksys SGE2000P switches in my network, i was checking the datasheets for these switches and they indicate that these switches can do Layer 3 routing, i need to setup VLANs in my network then use a Linksys SGE2000P switch to do the Inter-VLAN routing between the different VLANs. How do i configure the switch to operate in Layer 3 mode, i cannot see any settings in the GUI for configuring L3 routing.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...