Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Linksys SRW2048 connection problems

So I have read about proper procedure involving the connection between a console cable and Hyperterminal. I have also tried plugging into a network port to obtain an IP Address but nothing seems to work. When powering on the switch I see that it lights up, hear fans spin and assume it has booted properly. I'm using Hyperterminal on Windows Xp Pro SP3 and I've also tried minicom in Fedora. Is there any other trick someone could offer?

And just FYI Hyperterminal was set to the proper:

Bits per second: 38400

Data bits: 8

Parity: None

Stop Bits: 1

Flow Control: None

Any help or ideas would be greatly appreciated!!

1 REPLY
Bronze

Linksys SRW2048 connection problems

Change bits per second to 9600

1063
Views
0
Helpful
1
Replies
CreatePlease to create content