load an image on a 3750 which flash has been formatted

[ppellettiere]

While trying to upgrade an image on a 3750 the atchive/download crashed causing the image to corrupt. Now the switch boots up in to "switch :". The flash has been formatted. I would like to know if I can load andrun image on it to get it to boot up? If so what wiould the procedure be?

[adamclarkuk_2]

From switch: prompt do the following:-

flash_init

load_helper

check if there are any other IOS images on the flash by typing

dir flash:

if there is another one, boot from that

boot flash:image.name

if not copy one over. The complete procedure is here:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

[ppellettiere]

no images in flash:. just started the XMODEM procedure.

Thank You

Pete