Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

load an image on a 3750 which flash has been formatted

While trying to upgrade an image on a 3750 the atchive/download crashed causing the image to corrupt. Now the switch boots up in to "switch :". The flash has been formatted. I would like to know if I can load andrun image on it to get it to boot up? If so what wiould the procedure be?

2 REPLIES

Re: load an image on a 3750 which flash has been formatted

From switch: prompt do the following:-

flash_init

load_helper

check if there are any other IOS images on the flash by typing

dir flash:

if there is another one, boot from that

boot flash:image.name

if not copy one over. The complete procedure is here:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

New Member

Re: load an image on a 3750 which flash has been formatted

no images in flash:. just started the XMODEM procedure.

Thank You

Pete

268
Views
0
Helpful
2
Replies
CreatePlease to create content