Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load Balance WAN

People,

How to configure load balance with two link serial into same router?

This links go out for internet.

Thanks

5 REPLIES
Hall of Fame Super Silver

Re: Load Balance WAN

Marcio

The most simple and frequently best was to load share over 2 serial links is to configure 2 static default routes, one static default route pointing at each serial interface (or next hop address over the serial interface).

HTH

Rick

New Member

Re: Load Balance WAN

Rick,

Thanks for your answer, but this not possible because that link go out for internet and need use NAT.

I tried this, but he did not function.

Do you have another sugestion?

Thanks

Hall of Fame Super Silver

Re: Load Balance WAN

Marcio

NAT does not need to intefere with using static default routes. What was the problem?

HTH

Rick

New Member

Re: Load Balance WAN

Rick,

If i not use NAT, i can?t go out for internet.

I try again

New Member

Re: Load Balance WAN

People,

Follow the link with solution this problem.

http://www.ciscotaccc.com/kaidara-advisor/iprout/showcase?case=K81227071

Thanks

237
Views
5
Helpful
5
Replies