Hi all, i have 4 vlans, 1 2 3 4.. and there is another vlan 5 which contains 3 servers in it, switch that i am using is 2950, now my objective is, when first requset comes from any vlan, it should be forwarded to Server1, second should be to Server2, third should be to Server3, then again to server1 like in a round robin fashion,
You should use a third party load balancer in between 2950 switch and servers. I really do not know how loadbalancing is possible in 2950 swicthes without 'another' loadbalancer. I believe it is not possible.
In 6500 series switches you have the facility of SLB (Server load balancing) where you define a particular 'sever-farm' and then incorporate loadbalancing.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...