Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

loadbalnce over L2 WAN

hi guys

i have a customer with three sites over L2 WAN and each site has its own IP and static route between all sites for communication is configured

if one site only has new added link for this WAN netwrok how we can load blance those tow links other than useing tow static routes

i am awre about tow static routes that can do per packet or per destinationloadbalncing but this is for outbound traffic for the site that has tow links

is it possible to be done like virtulization

have one IP like VIP to to bundell those tow links?

also if for example used CSM or CSS how it can be configured


Hall of Fame Super Silver

Re: loadbalnce over L2 WAN

Hello Marwan,

Happy New Year

I'm not sure if I've understood your question.

The only way to use two WAN links as only one could be some form of L2 bundling

FR multilink FRF.16

I think you are using a FR service if so FRF.16 FR multilink gives you this option.


You will need to cooperate with FR provider to implement it.

FRF.15 and PPP multilink are instead suitable for end-to-end bundling but it shouldn't be your case (you say you added a second link on only one site)

Hope to help


Re: loadbalnce over L2 WAN

hi Giuseppe

happy new year to u too

no it is not Fram relay it is shdsl

the router has to Fa link each one go to a s mall cisco shdsl router that used as bridge and the service is act as L2 not sure if it is MPLS or VPLS


the site with two links how i can bundell those tow links as one

with static route can be done for outbound only!!

PBR can do load share but this is manuel !!

thanks anyway

Hall of Fame Super Silver

Re: loadbalnce over L2 WAN

Hello Marwan,

no bundle option in your case I'm afraid; you need to use multiple static routes

Hope to help