Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Local device is not AED-Capable - OTV

Hi All

 

Setting up OTV for the first time. We are using multicast mode.

 

I have 2x OTV VDCs on one end, and a pair on the other:

 

Site2 OTV1            ---             Site2 OTV2

   |                                                 |

   |                                                 |

Site1 OTV1           ---              Site1 OTV2

 

Apparently, I see both the OTV2 VDC's have been working good, and formed adjacencies between themselves, but both site 1 OTV VDCs complain that they arent AED capable. Im not aware of a way to manually enable this on these VDCs. The configurations are MATCHED between the OTV VDC's and Core/Aggr VDCs.. Everything is exact same.

 

This is the output for show otv site

Local Edge Device Information:
    Hostname R1-Demo-N7K-OTV1
    System-ID 001b.54c2.a4c6
    Site-Identifier 0000.0000.0002
    Site-VLAN 501 State is Up

Site Information for Overlay150:

Local device is not AED-Capable (No Overlay Remote Adjacency up)
Neighbor Edge Devices in Site: 1

Hostname                 System-ID        Adjacency-       Adjacency-   AED-

                                          State            Uptime       Capable

--------------------------------------------------------------------------------
(null)                   b414.89dd.fa46   Partial           00:51:54     Yes

 

Regards

Raj

Everyone's tags (2)
1 REPLY

This looks like you have the

This looks like you have the local site adjacency up bewteen your two edge devices, but there is no adjacency to the remote site.  The OTV will not allocate VLANs to AEDs until there is some remote site adjacency.  Have a look at "show otv adjacency" on your OTV VDC.

Kevin Dorrell
Luxembourg

741
Views
9
Helpful
1
Replies
CreatePlease login to create content