The support for this command was introduced in 12.2(25)SG. Here is a brief synopsis from the command reference:
logging event link-status global (global configuration)
To change the default switch-wide global link-status event messaging settings, use the loggingeventlink-statusglobal command. Use the no form of this command to disable the link-status event messaging.
This command has no arguments or keywords.
The global link-status messaging is disabled.
Support for this command was introduced on the Catalyst 4500 series switch.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...