cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
506
Views
0
Helpful
3
Replies

logging event

arun
Level 1
Level 1

Is there any specific show command to find out the interfaces which logging event (logging event link-status) enabled except sh run && sh run int.

3 Replies 3

glen.grant
VIP Alumni
VIP Alumni

If its enabled globally all interfaces will have it turned on if not then you would have to parse thru the running config and look.

Also, be aware that in some model series the "logging event link-status" is enabled by default while on others it is disabled by default.

If it is the default, then it does not show up in the config, meaning that if the model of switch you are trying out has logging event link-status enabled by default then the line will not be in the config even though the feature is actually active.

HTH

Leo Laohoo
Hall of Fame
Hall of Fame

logging event link-status is disabled by default on all the supervisor engines of the 4000/4500, Sup32 and Sup720. This includes the 4900 series. Other switches are enabled by default.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: