Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Logging snmp linkdown/linkup 3750's

I must be having a brain sludge day.

Senario

2 x 3570's (stackmembers) at location A

2 x 3570's (stackmembers) at location B

they are connected via 2 trunks in a etherchannel group.

The question is for command

snmp [authentication |

coldstart | linkdown |

linkup | warmstart]

I'd like to only be notified of the up/down status on the trunked interfaces only and not of any of the other interfaces configured as switchport access.

Thoughts..Thanks

1 REPLY
Purple

Re: Logging snmp linkdown/linkup 3750's

Make sure you have " no snmp trap link-status " on all user access ports . Not sure if that is the exact syntax but its close just use your tab key for the correct commands.

147
Views
0
Helpful
1
Replies
CreatePlease to create content