Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

login and psw

Someone could please provide me the command i need to place (on 3560 EMI and 6509 IOS, but i think it's the same) in order to change login and psw for telnet and consolle access. (with ecritption too) thanks,

simone

1 REPLY

Re: login and psw

use "service password-encryption" command in config mode to encrypt passwords.

To change telnet and vty password, configure new password under interface config mode and you should be good to go.

line vty 0 4

password

linet console0

password

HTH, rate if it does ....

151
Views
0
Helpful
1
Replies