Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

long Attributs

HI

When/where we need to made redis with these long Attributs

redistribute ospf 1 match internal external 1 external 2 metric 1 1 1 1 1

many 10xs

2 REPLIES

Re: long Attributs

Hi,

the LONG attributes have many things included!!!

1st internal and external matching:

When you use match keword with redistribution you can ask the router to redistribute the internal and external type 1 and type 2 (of ospf in this case)to redistribute in to another routing protocol doamin.

2nd:

The 1 1 1 1 1 metric is used under eigrp for BW Dealay load etc parameters.If you configured the redisribution with these values the metric will be very low.

Under ospf metric can not be 1 1 1 1 1.

It should be only one number the cost.

Such attributes help you to have control over redistribution.

HTH,

regards,

shri :)

Hall of Fame Super Blue

Re: long Attributs

Hi Ali

This is redistributing OSPF routes, both internal and external type 1 and external type 2 into IGRP/EIGRP.

The 1 1 1 1 1 are needed because IGRP/EIGRP use 5 separate values for their metric.

Jon

119
Views
0
Helpful
2
Replies