12-23-2006 07:22 AM - edited 03-05-2019 01:28 PM
hi,
Can I know how to check for the switch mac-address table in CATOS?
12-23-2006 07:31 AM
sh mac-add-table
12-23-2006 07:40 AM
this command is invalid in CATOS
12-23-2006 07:33 AM
Use " show cam " in CatOS.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_1/cmd_ref/sh_a_c.htm#wp1028328
HTH, Please rate if it does.
-amit singh
12-23-2006 08:06 AM
chk this out:
sh cam dynamic "vlan-id".
hope this helps.
12-25-2006 01:48 AM
show cam dynamic
If you want to see the static cam entries, then you can give
show cam static
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide