Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Loopback Interface??

  Hi,

I want to know why do not have MAC address on loopback interface on Router or Switch??

If I see on useing #show int loopback 0

There is no MAC address.

If these are not support the MAC address then it's only depend on IP even on WAN area??

Please your helpful reply require..

3 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: Loopback Interface??

Let us start the explanation by reviewing a fundamental concept about MAC address. The purpose of a MAC address is to distinguish individual devices on the media (it is a link local layer 2 address).
Since the loopback interface is by definition not connected on any physical media there is no purpose in a link local address and MAC addresses are not supported on loopback interfaces.

HTH

Rick

Cisco Employee

Re: Loopback Interface??

Hello,

Yes, the ping is via the IP addresses and IP routing. There is no

encapsulation required for that.

Regards,

NT

Hall of Fame Super Silver

Re: Loopback Interface??

Encapsulation is how you build a header for a particular physical media. Since there is no physical media associated with a loopback interface there is no encapsulation associated with a loopback interface.

HTH

Rick

5 REPLIES
Cisco Employee

Re: Loopback Interface??

Hello,

Loopback interfaces are virtual interfaces created in software by the router/switch. Unlike other virtual interfaces, the loopback interface will not have any physical connectivity with another device. Whoever needs to communicate with the loopback interface need to go through another physical interface enabled with IP routing. So, communication between that physical interface and the loopback interface happens in software (no need of MAC). Hence you do not need a MAC address for the loopback interface.

Hope this helps.

Regards,

NT

Hall of Fame Super Silver

Re: Loopback Interface??

Let us start the explanation by reviewing a fundamental concept about MAC address. The purpose of a MAC address is to distinguish individual devices on the media (it is a link local layer 2 address).
Since the loopback interface is by definition not connected on any physical media there is no purpose in a link local address and MAC addresses are not supported on loopback interfaces.

HTH

Rick

New Member

Re: Loopback Interface??

If Router A have loopback and Router B is can ping to loopback int. of Router A, so only on basis of IP address ping to same??

any idea abour encapsulation loopback??

Cisco Employee

Re: Loopback Interface??

Hello,

Yes, the ping is via the IP addresses and IP routing. There is no

encapsulation required for that.

Regards,

NT

Hall of Fame Super Silver

Re: Loopback Interface??

Encapsulation is how you build a header for a particular physical media. Since there is no physical media associated with a loopback interface there is no encapsulation associated with a loopback interface.

HTH

Rick

5997
Views
0
Helpful
5
Replies
CreatePlease login to create content