Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Lose config on 6506 switch

After a power off of our switch we keep losing the config. I have made sure the start config and running config are the same. What I did find is the config register is set to 0x9006???? I have never seen this....can someone enlighten me as I think this is the problem. The config stays under normal operation just gets lost on power off and on.

Thanks,

Mike

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Lose config on 6506 switch

Hi Mike,

config register 0x9006 means "enable diagnostices & ignore NVRAM & also the baud rate is 1200" set the config register as 0x2102 or 0x2 for normal operation.

hope this helps.

3 REPLIES

Re: Lose config on 6506 switch

Hi Mike,

config register 0x9006 means "enable diagnostices & ignore NVRAM & also the baud rate is 1200" set the config register as 0x2102 or 0x2 for normal operation.

hope this helps.

Re: Lose config on 6506 switch

That is what I thought but I just wanted to check. I have since found a Config reg tool that told me just that.

Thanks,

Mike

Re: Lose config on 6506 switch

Hi Mike,

if this issue is been solved, please update in this forum as it might be helpful for others.

Anand

192
Views
0
Helpful
3
Replies
CreatePlease login to create content