Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

loss config R2620

my router do not keep its config after doing copy run start

1 REPLY
Hall of Fame Super Silver

Re: loss config R2620

The most common cause of this symptom is that the configuration register has been set to ignore the startup config at boot time. What is the value of the config register on your router? It is displayed near the bottom of the output of show version.

I am guessing that it is set to something like 0x2142 (the 4 is the important digit for this discussion). If it is set that way you can put it back to normal using the command in global config: config-register 0x2102

HTH

Rick

94
Views
0
Helpful
1
Replies