Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

< 6148a > problem, pls help me~

I'm Chinese, there is a problem with my work,thank you all first!

########################################

the enviroment:

UNKNOWN line card: ws-x6148a-ge-tx

Cisco Catalyst 6506 with super engin 2

Old IOS 12.1 (Running IOS)

new IOS s222-ipservicesk9_wan-12.2-18.sxf6.bin (prepare to Upgrade)

PCMCIA Flash card 64M (new ios is 50M, placed here)

sup-bootflash:64M running ios is placed here

config-register 0x2102

bootvar:

boot system disk0:

boot system disk0:s222-ipservices.....

boot system flash disk0:s222...

boot system flash sup-bootflash:c6k...(Running IOS)

rommon 1> dev

..... pcmcia ... slot0(disk0: was shown in ios, slot0 here in Rommon??)

#########################################

with the configuration was shown,the switch was able to start with disk0,just as the PCMCIA card was not in ! it start with sup-bootflash everytime!

help me , i was so worry about that i did't eat anything all the day..

My English is not very good,if the situation i had shown is not very clearly, pls tell me ,

my msn is love.leo@msn.com

2 REPLIES
Community Member

Re: < 6148a > problem, pls help me~

the key is that how does the switch can boot from the disk0, i think

Community Member

Re: < 6148a > problem, pls help me~

The problem has been Fixed!!

the key is that my Rommon version is 6.1, but the ata flash card need the Rommon version up that 7.1 on super engin 2

when i had upgrade the Rommon version to 7.1,the ata flash card has been read sucessfully !!!

and than the sw start form the disk0: loading the new ios .

V

123
Views
0
Helpful
2
Replies
CreatePlease to create content