I am having a setup of 13-14 switches. Its a mix of cisco , non cisco, unmngabled (dlink) switches.
When I try to find a device on which switch it is conncted by tracing MAC address table. Most of the time I end up on switch (Say Switch A) whose mac adddress table point me back to the uplink. When I follow uplink switch it points me back to switchA.
What could be the reason? Any configruation to avoid such situation.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...