Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mac address security

Hi,

How do we check the max mac limit configured on the switch for permissible no. of mac address. For example, a switch might have been set for allowing only 25 mac address in numbers, allowed on the configuration.

Is there any command to check this?

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

mac address security

Hi ,

I am totally agree with John.

you can find on each interafce that how many mac add. are there on a port and how much maximum you can assign.

there are 3 commands:

sh port-securty

sh port-security int fa0/--

sh port-security address .......

Reagrds

2 REPLIES

mac address security

hi,

you can use the show port-security or the show port-security interface x/x commands. see sample output below.

Switch#show port-security

Secure Port  MaxSecureAddr  CurrentAddr  SecurityViolation  Security Action

                (Count)       (Count)          (Count)

---------------------------------------------------------------------------

      Fa0/1              2            0                  0         Shutdown

---------------------------------------------------------------------------

Total Addresses in System (excluding one mac per port)     : 0

Max Addresses limit in System (excluding one mac per port) : 8192

Switch#show port-security interface f0/1

Port Security              : Enabled

Port Status                : Secure-down

Violation Mode             : Shutdown

Aging Time                 : 120 mins

Aging Type                 : Absolute

SecureStatic Address Aging : Disabled

Maximum MAC Addresses      : 2

Total MAC Addresses        : 0

Configured MAC Addresses   : 0

Sticky MAC Addresses       : 0

Last Source Address:Vlan   : 0000.0000.0000:0

Security Violation Count   : 0

VIP Purple

mac address security

Hi ,

I am totally agree with John.

you can find on each interafce that how many mac add. are there on a port and how much maximum you can assign.

there are 3 commands:

sh port-securty

sh port-security int fa0/--

sh port-security address .......

Reagrds

172
Views
3
Helpful
2
Replies
CreatePlease login to create content