Hi, we have a Nexus 5548 in our test/dev environment, but for some reason it isn't learning Mac Addresses. If I submit a "show mac address-table", bothing comes back. We have about 20 nodes on the switch. Should be coming back with something. This is a typical config, nothing fancy. It does have spanning-tree rspd and portfast on the ports. The trunks only allow 2 Vlans.
Can you help explain some reasons why the mac address are not showing? Thanks
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...