The scenario is in my network there are three devices connected 1 cisco router and 2 L2 switch.
First route 1 connected SW1 and SW1 connected to SW2. The SW2 has mac security enabled, it only allow one mac address with security violation shutdown.
What my problem is SW1 forwarding 2 mac address to SW2, one router's mac address and its own connected mac. So SW2 is blocking the port connected to SW1. Is there any way to forward only one Mac address of routers instead of SW1 to SW2.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...