Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MACsec on Cat 3750G switches (switch to host)

Dear All,

We are trying to enable Macsec (switch to host) on switchports but couldn't find following commands. We are running 15.0(2)se4 IPBASE image.

Switch(config-if)#macsec 
Switch(config-if)#mka policy xx

Both the above commands are not available. I was able to create the MKA policy on the switch in the global configuration mode.

As per below guide MACsec is supported on IPBase images, dont know why above commands are not there.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/15-0_1_se/configuration/guide/3750xcg/swmacsec.pdf

 

Regards,

Akhtar

 

 

 

 

 

 

Everyone's tags (1)
2 REPLIES
Hall of Fame Super Silver

 The guide you are citing

 

The guide you are citing speaks to MACsec support on the 3750-X and 3560-X.

Your older 3750-G switch does not support MACsec due to hardware limitations. Please refer to the table on page 6 of the Trustsec Platform Support matrix

New Member

We trying the same commands

We trying the same commands on 3750-x switch but its not available. Even we can't MKA policy command on it and we are running the ip base image. Any suggestions ?

 

Regards,

Akhtar

369
Views
0
Helpful
2
Replies
CreatePlease to create content