Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Manage cluster member ports from cluster cmd on 2960?

Is it possible to manage the ports of my cluster members from the CLI on the commander? I would like to have a setup similar to that of the 3750 stack where switch one is gig0/1 and switch two is gig1/1 ...etc

I have clustering configured but when I do a sho ver I only see one switch in my list.

Thanks!!

1 REPLY
Silver

Re: Manage cluster member ports from cluster cmd on 2960?

The following URL will help you

Configuring a Management Interface for 2900/3500 XL Switches :

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008010e9ca.shtml

Configuring the Basic Switch Information :

http://www.cisco.com/en/US/docs/switches/lan/catalyst2900xl_3500xl/release12.0_5_wc_1_/swg/swgsyst.html

116
Views
0
Helpful
1
Replies